Posiflex PD-2605UE - Manual (Page 3)

Part 3
INSTALLATION GUIDES
HOST SYSTEM PREPARAION
For serial interface (RS232) PD-309 or PD-2605 to be used in KS-2010A, KS-
6810, DT-20X and Gen.6 & 4.5 base of KS series, you have to adjust during
power off the internal jumper of the host system to supply 5 V DC to the
COM port selected for the serial interface pole display. This adjustment has to
be done by a qualified electronic technician following guide from relevant
technical manual. The default communication protocol should be set to 9600
bps, none parity, 8 data bits, 1 stop bit with hardware handshaking on CTS.
The power for the USB interface type pole display is supported through the
USB connection. However, should these customer displays are to be connected
through an USB HUB instead of a direct USB port of the system, the HUB
must be powered by a separate power adaptor otherwise there could be the
power shortage problem.
INSTALLATION
The PD-309 or PD-2605 can be
attached to the corner in bottom
plate of the KS-2010A, KS-
6810, with slim base, DT-20X
and Gen.6 & 4.5 base of KS
series. It takes examples of this
LCD customer display to fix in
the KS-2010A, KS-6810, and
DT-20X. Refer to the pictures
in Pix.1 at right. Use the 3 attached screws to fix the metal
base plate of the PD to bottom of mini slim base or DT-
20X at the circled positions. For mini slim base Connect
the interface cable to go into the base through cable exit
arrowed in Pix.2 at right to the main unit. For DT-20X
arrange the interface cable to go through under bottom to
connector area arrowed in Pix.1 at above right.
CAUTION: There are self-tapping screws for PD-309/ PD-2605 when use
in Gen.4.5 base stand and please aim to the holes which marked “DT” as
showing in the upper picture Pix.1. Other Bing Head Screws are use when
fix in KS-2010A, KS-6810, DT-20X and Gen.6 base stand of KS series.
Pix. 2
Pix. 1
Base for KS-2010 Bottom of DT-20X