Posiflex TX-3100E - Manual (Page 8)

Page 8
Connecting Cash Drawer (Option)
The RJ11 connector in I/O area of a TX-3100/TX-3100S/TX-3100RS system
can be used for controlling most of the common cash drawers available on the
market.
However, it is most recommended to use Posiflex CR-2000 or CR-2200 or
CR-3100 or CR-3200 or CR-4000 or CR-4100 or CR-4210 or CR-6310 for
best compliance to operate the opening mechanism and to monitor the drawer
open status.
Use the cable supplied with the cash drawer for connection to the CR port in
TX system. This cable has a 6-pole plug at one end and an 8-pole plug at the
other. The 8-pole plug should be inserted into the connector marked: “signal
cable from POS Printer” at the rear of the cash drawer. The 6-pole plug should
be inserted in the connector marked “CR” found in the main connection area in
the system.
Wall Mount Application
In order to present in clearly organized visuals and freeing up
valuable desk space, TX-3100/TX-3100S/TX-3100RS series
support wall mount application and VESA 75mm standard. After
screw-fit the upgrade kit WB-6812 bracket, TX-3100/TX-
3100S/TX-3100RS can apply mounting function and VESA
standard application. For installation step, please refer to the WB-
6812 installation guide.
System Recovery
For TX systems preloaded with Windows POS Ready / Win 7 / Linux on HDD
or Solid State Drive, Posiflex provides recovery
DVD delivered with the terminal for the preloaded operating system. The
System Integrator shall take care of software restoration after OS
recovered. A Posiflex supplied USB interface DVD drive will be required for
such action. Other brand DVD-ROM drive may require its own driver different
from what supported in the recovery DVD.
Please use the recovery DVD in rescue operation only. Using it otherwise
may wipe out whatever stored in the storage device! All upgrade devices