Posiflex TX-3100E - Manual (Page 5)

Page 5
INSTALLATION GUIDES
Hardware Power Switch
The power switch located in the front bezel of main
unit. It is a pushbutton switch and controls the
power on/off of the whole system.
This power switch turns the system on when pushed
only. This switch turns the system off when pushed
again during power on status. However, if the system hangs due to any reason
such as software resource conflict, a simple push on the switch in 10 sec may
turn off the power.
Note: There must always be at least 10 seconds waiting before switching
on again once the system is powered off successfully.
Indicators of power, status and HDD
There is power indicator serving for several purposes at
front bezel. For HDD indicator (For TX-3100RS only), it
will flash orange light when the HDD is operating. The
relationship between the indicator status and other
conditions of “PW LED” is summarized in following table:
CAUTION: Before any installation or cable connection to
the set, please always make sure that the system is turned off
and the external power source to the set is removed to prevent
electric hazard! Never touch any metal pin in the connectors
or circuits to avoid high voltage hazard or electrostatic
discharge damage unless the operator is well grounded.
Failure to do the above will void the product warranty!
Indicator Terminal Status LED colour
Standby Orange
Power Status
Power On Blue
This indicator
for TX-3100RS
only.