Posiflex TX-4600 - Manual (Page 5)

Page 5
INSTALLATION GUIDES
Hardware Power Switch
The power switch is located in the front bezel of main unit. It is a pushbutton
switch and controls the power on/off of the whole system.
This power switch turns the system on when pushed, and will turn the system
off when pushed again while the system is powered on. However, if the system
hangs for any reason, simply pushing the power switch for at least 10 seconds
can power off the terminal.
Note: There must always be at least 3 seconds waiting before switching on
again once the system is powered off successfully.
Indicators of power status
There is one power indicator LED module serving for several purposes at front
bezel. For power indicator, it will flash green light when the TX is operating.
The relationship between the indicator status and other conditions of “Power
LED” is summarized in the following table:
CAUTION: Before any installation or cable connection to the set, please
always make sure that the system is turned off and the external power
source to the set is removed to prevent electric hazard! Never touch any
metal pin in the connectors or circuits to avoid high voltage hazard or
electrostatic discharge damage unless the operator is well grounded.
Failure to do the above will void the product warranty!
Display Issues
VGA Port
Do not connect other monitor except for Posiflex to this port before the
power in this port is disabled. The VGA port in the TX-4600 series system
supports either a separately connected LCD monitor or touch monitor. To
support the DC power to the display monitor, it requires a qualified technician
Indicator Terminal Status LED colour
Standby Red
Power Status
Power On Green