Posiflex PG-200/2D - Manual (Page 9)

Enable/Disable UPC-E1
UPC-E1 is disabled by default. To enable or disable UPC-E1, scan the
appropriate bar code below.
Note: UPC-E1 is not a UCC (Uniform Code Council) approved symbology.
Enable UPC-E1
< Disable UPC-E1 >
Enable/Disable EAN-8/JAN-8
< Enable EAN-8/JAN-8 >
Disable EAN-8/JAN-8
Enable/Disable EAN-13/JAN-13
< Enable EAN-13/JAN-13 >
Disable EAN-13/JAN-13
Convert UPC-E to UPC-A
Enable this to convert UPC-E (zero suppressed) decoded data to UPC-A
format before transmission. After conversion, the data follows UPC-A format
and is affected by UPC-A programming selections (e.g., Preamble, Check
Digit). When being disabled, UPC-E decoded data is transmitted as UPC-E
data, without conversion.
Convert UPC-E to UPC-A (Enable)
9