Posiflex PG-200/2D - Manual (Page 6)

7 msec
8 msec
9 msec
Symbologies
The device is shipped with the settings shown in the Symbology Default Table
if the default values suit requirements; programming is not necessary.
There are two ways to change a parameter value:

Scan the appropriate bar codes in this guide. These new values replace
the standard default values in memory.

For SSI and USB SNAPI hosts, send a “parameter send” command from
the host system. Hexadecimal parameter numbers are shown in this section
below the parameter title, and options are shown in parenthesis beneath the
accompanying bar codes.
Note: Most computer monitors allow scanning the bar codes directly on the
screen. When scanning them on the screen, be sure to set the document
magnification to a level where the bar code can be seen clearly, and bars
and/or spaces are not merging.
To return all features to default values, scan the Set Default Parameter bar
code. Throughout the programming bar code menus, default values are framed .
Symbology Default Table
Parameter Default
UPC/EAN
UPC-A Enable
UPC-E Enable
UPC-E1 Disable
EAN-8/JAN 8 Enable
6