Posiflex PG-200/1D - Manual (Page 13)

 Enter prefixes and suffixes in the order in which you want
them to appear on the output.
 When setting up for specific symbologies (as opposed to all
symbologies), the specific symbology ID value counts as an
added prefix or suffix character.
 The maximum size of a prefix or suffix configuration is 32
characters, which includes header information.
To Add a Prefix or Suffix:
Step 1: Scan the Add Prefix or Add Suffix symbol.
Step 2: Determine the 2 digit Hex value from the Symbology
Chart (included in the Symbology Charts) for the
symbology to which you want to apply the prefix or
suffix. For example, for Code 128, Code ID is “j” and
Hex ID is “6A”.
Step 3: Scan the 2 hex digits from the Programming Chart inside
the back cover of this manual or scan 9, 9 for all
symbologies.
Step 4: Determine the hex value from the ASCII Conversion Chart
for the prefix or suffix you wish to enter.
Step 5: Scan the 2 digit hex value from the Programming Chart
inside the back cover of this manual.
Step 6: Repeat Steps 4 and 5 for every prefix or suffix character.
Step 7: To add the Code I.D., scan 5, C, 8, 0.
To add AIM I.D., scan 5, C, 8, 1.
To add a backslash (\), scan 5, C, 5, C.
Note: To add a backslash (\) as in Step 7, you must scan 5C twice
– once to create the leading backslash and then to create
the backslash itself.
Step 8. Scan Save to exit and save, or scan Discard to exit without
saving. Repeat Steps 1-6 to add a prefix or suffix for
another symbology.
13