Posiflex JIVA HS-2310 - Manual (Page 17)

Part 17
on/off of the system. After external power is preset, this
switch turns the system on when pushed only. This switch
turns the system off when pushed again during power on
status. However, if the system hangs due to any reason such
as software resource conflict, a simple push power switch
may fail to turn off the power. In this case, please utilize the
forced power off feature by pressing the power switch and holding for more
than 15 seconds.
There must always be at least 10 seconds waiting before switching on again
once the system is powered off successfully.
Automatic Power On Control
The system may also turn on according to some preset conditions such as
Alarm Clock Wake Up or LAN Wake Up.
To utilize Alarm Clock Wake Up function, the user should enter the BIOS
setup by pressing “Del” key at system boot up, choose in “Power Management
Setup” and make the “Resume by Alarm” for Alarm Clock Wake Up. Save the
configuration and exit the BIOS setup program.
The Preset Power On Control will then be ready. For LAN wakeup, the item
“PCI Express PM Function” must be enabled in “Power Management Setup”
and an operating caller system connected through LAN to the system is
required. It also requires a qualified networking technician to check the LAN
chip ID of the system for the caller system to wake up.
When the terminal is turned off after a successful boot up with external power
continuously supplied, the preset automatic power on functions will keep
monitoring for the preset conditions and turn on the system when the preset
conditions are met. Please note that if the terminal is improperly turned off
before a complete boot up procedure, the above preset power on control
functions will be disabled until next turning off after a complete boot up.
USB PORTS
There are in total 5 USB ports for external connection: 1 at left side above
power switch; 1 in upper rear I/O area; the other 3 in bottom rear I/O area; All
of them comply with USB 2.0 standard.