Posiflex JIVA HS-2310 - Manual (Page 13)

Part 13
mode” even though your workstation does not.
If this occurs, you will need to
reboot the system. Please check with your application developer for
compatibility.
Cleaning the Sensor
Depending on the available amount, the sensor window
may need to clean periodically. To clean it, apply the
sticky side of a piece of adhesive cellophane tape on the
window and peel it away as in the drawing at right.
Under heavy usage, the window coating on some sensors may turn cloudy
from the salt in perspiration. Gently wipe the window with a cloth (not paper)
dampened with a mild ammonia-based glass cleaner.
Note: With the purpose of acquiring a clear finger image; please position your
finger on the pad gently and not only the tip in the center of the sensor window.
Do not “roll” your finger and please notice that it will distort your fingerprint
if pressing too hard or light will not expose a large enough area of your finger.
MSR
For magnetic stripe card reading, be sure to insert the card to the bottom with
magnetic stripe facing upward and toward the arrowed triangle mark aside the
slot. There is a “Posiflex USB MSR Manager”
program provided to control some parameter
configuration for ISO MSR. The features
controllable in this program cover: each track
enable/disable, Alt+Num approach for ASCII
codes and Leading/Stop code enable/disable.
USB SMART CARD
Card Insertion
For smart card reading, please
insert the end of the smart
chip first and have the chip
facing upward and toward the
triangle mark aside the side slot
of HS as in the example picture
in the right side view. Under
power saving mode, when the
card is removed, the USB connection is disconnected from host, vice versa.