Directed Electronics ESP 540 User Manual

Page 14

1999 Directed Electronics, Inc.

IMPORTANT! The Valet

switch can be programmed to respond to 1-5

presses for the disarm function. You must check with the installer to ver-
ify the programming for your individual unit.

LOCATION OF VALET

SWITCH_____________________________

Use the Silent Mode to temporarily turn off the arming or disarm-

ing confirmation chirps by briefly pressing

before either arm-

ing or disarming the security system. The confirmation chirp(s) will

then be eliminated for that one operation only. To permanently

turn off the confirmation chirps, contact your installation dealer.

NOTE: The Warn Away

Response to lighter impacts is bypassed if the sys-

tem is armed using the Silent Mode. This ensures that the siren does not
chirp in an environment where you don't want chirps to be emitted. The
system is still capable of being triggered by heavier impacts; only the
Warn Away

Response generated by light impacts is bypassed.

If you are threatened in or near your vehicle, you can attract

attention by triggering the system with your transmitter! Just

press

for 1 second, and you will enter Panic Mode. The siren

will sound and the parking lights will flash for 30 seconds. To stop

Panic Mode at any time, press

on the transmitter again.

Valet

Mode prevents your system from arming and triggering either

automatically or when using the remote. In Valet

Mode, all conve-

nience functions (door locks, trunk release, etc.) remain operational.

This feature is useful when washing or servicing your vehicle.

Valet Mode

Panic Mode

Silent Mode