Paso Sound WPSS150M - Manual (Page 28)

-27-
2.Making changes to Battery selection:
Use UP or DOWN button to go to the Battery selection page.
Press SET for about 2 seconds to activate the cursor. Press UP or DOWN button to move
the cursor to either NiMH (rechargeable battery) or AKLN (Alkaline battery) position.
When the desired option has been selected, press SET for about 2 seconds to save and
store the data in the memory.
Remark : "NiMH" must be selected when rechargeable battery is being used. Never select
"AKLN" (Alkaline) when transmitter is intended for charging as Alkaline battery can not be
charged ! Wrong selection of battery will cause battery sensing electronics to display wrong
information and mislead charging status.
3.Input Level Gain Control Adjustment
Low impedance (Lo-Z) " MT" & high impedance (Hi-Z) " GT" gain controls are situated
inside the transmitter. Gain controls are adjustment ports that enable you to use
microphones of differing output levels and Guitar or instruments with Hi-Z output. To
adjust microphone (Lo-Z) input levels, turn the "MT" control and to adjust the Guitar or
instrument (Hi-Z) input, adjust the "GT" gain control to set the transmitter's desired audio
input level.
FCC Caution
To assure continued compliance, any changes or modifications not expressly approved
by the party responsible for compliance could avoid the user's authority to operate this
equipment. (Example - use only shielded interface cables when connecting to computer or
peripheral devices.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause
undesired operation.