Dolby Laboratories DVD26 - Manual (Page 7)

3
DVD26 DVD AND CD PLAYER USER GUIDE
HOW TO GET STARTED
This chapter provides a quick overview of how
to connect the DVD26 player and how to start
playing discs. More detailed explanations of all the
various functions are explained in the following
chapters.
Power connection
WARNING: Before connecting power
check that the required supply voltage, in-
dicated on the back panel, cor re sponds to
your local AC supply. If a different voltage
is stated on the type plate do not connect the DVD26 to
the mains power, and seek advice from your dealer.
Connect the mains power using the enclosed mains cable.
NOTE: Always disconnect the DVD26 and all other units
in the system from the mains power before connecting or
disconnecting any of the cables. Failure to do this might
seriously damage the unit.
Switching on and off
To switch on
• Use the main switch on the back panel.(F).
During normal operation you can leave the DVD26
switched on and in standby mode.
To switch on from standby or to standby
• Pressing on the front panel or on the remote con-
trol, will change the standby mode.
When not used for more than 60 min, the DVD 26
automatically switches to standby mode.
Back panel connections
A. Component video output, progressive
B. VGA Video output, progressive
C. External IR/input
D. Data Port
E. RS232 port
F. Mains switch
G. Main power input and fuse
H. Digital SPDIF output
I. Digital TOSlink output
J. Analog RCA outputs
K. Scart
L. Component Video output, interlaced
M.Composite output
N. S-video output
G
C B A F D E
H I J K
L
M N