Dolby Laboratories DVD26 - Manual (Page 22)

18
DVD26 DVD AND CD PLAYER USER GUIDE
SETTINGS IN THE SETUP MENU
MOVE SETUP : Exit
AUDIO
PLEASE ENTER OLD PASSWORD
OLD PASSWORD :
NEW PASSWORD :
CONFIRM :
VIDEO LAN GENERAL PROG
• Use the number buttons to enter a 4-digit password.
It’s also possible to use the cursor buttonsto set the
password (up and down to set the number; left and
right to change the cursor position).
• Press SELECT to register the password.
Note! The password stays with operation 'Factory reset'.
Changing your password
To change your password, confi rm your existing password
then enter a new one.
• Select ‘Password Change’.
• Use the number buttons to enter your existing pass-
word.
– The numbers appear as asterisks as you enter them.
– It’s also possible to use the cursor bottons to set the
password (up and down to set the number; left and
right to change the cursor position).
• Press SELECT.
• Enter a new password.
• Press SELECT.
Factory settings
All setups you have made will be zeroed.
MOVE SETUP : Exit
AUDIO
RECALL FACTORY SETTINGS
PARANTAL LOCK
PARANTAL PWD
FACTORY SETTINGS
REMOTE IR
RESUME MODE
NO PARANTEL
CHANGE
RESET
FRONT REMOTE
OFF
VIDEO LAN GENERAL PROG
Remote IR
The DVD26 is controlled by an infra/red remote controll
pointed at the front panel.
The DVD26 can also be controlled using the IR/input at
the back panel.
MOVE SETUP : Exit
AUDIO
SELECT BACK/FRONT REMOTE
PARANTAL LOCK
PARANTAL PWD
FACTORY SETTINGS
REMOTE IR
RESUME MODE
NO PARANTEL
CHANGE
RESET
FRONT REMOTE
BACK REMOTE
VIDEO LAN GENERAL PROG
For security reasons this setting disappears every time the
DVD26 player is switched off using the main switch. You
have to go back to the setup menu to reactivate it.