OpenEye Gen6 X-Series Hardware Manual - Manual (Page 29)

TURNING ON YOUR RECORDER
1. Turn on the monitor and any printers or external storage devices, etc. connected to your recorder.
2. Turn on the Secondary Power Switch located in the rear of the recorder.
3. Press the Power Switch located on the front of the recorder.
4. The recorder will run a series of self-tests. If asked to respond to any messages, follow the
instructions carefully.
5. Startup is complete when the Server Software is finished loading and displays the main menu
screen.
TURNING OFF YOUR RECORDER
1. On the Live screen of the Server Software, click Exit.
2. Select Power Off, and then click OK.
3. The recorder may take several minutes to shut down completely.
Caution
Always be sure to follow the proper procedures when turning off the power. NEVER
disconnect the power to the recorder while it is still running or in the process of shutting
down. Doing so can cause data loss, file corruption, system instability and hardware failure.
32520AB 29