Onwa Marine Electronics KR-12X8 - Manual (Page 55)

11.
12. Fix the shield cover. Do not pinch the cable.
Loosely fasten the radome fixing bolts. You will tighten them after
confirming the unit is working normally.
Mounting(KR-1568)
Figure 6-5 Typical antenna unit mounting locations
1. Drill four fixing bolt holes (13 millimeters dia.), One cable entry hole (approx.
50 millimeters dia.) In the mounting platform. See the outline drawing.
2. Detach the antenna housing cover from the antenna housing by loosening four
fixing blots. The antenna housing cover fitted with the transceiver module can
be stored in a convenient place until the wiring to the antenna unit is done.
3. Place the antenna bousing on the mounting platform and orient it as shown in
Figure 6-6.
4. Insert four M12 60 hex head bolts with the seal washers from inside the
antenna housing, to prevent the bolts from contacting the transceiver module.
Install the seal washer with the larger diameter next to the head of the bolt.
Coat flat and spring washers and nuts and then use them to fasten the antenna
housing to the mounting platform. Finally, coat exposed parts of nuts, bolts and
SHip`s
bow SHip`s
bow
Figure 6-6 How to orient the antenna unit
48
Flat and spring washers as shown in Figure 6-7.