Onwa Marine Electronics KR-1338C v.1 - Manual (Page 58)

4. Fasten the cable gland assembly.
5. Connect the lead wires to CON-0906 in the antenna housing by referring to the
Interconnection Diagram. Fasten the ground washer at the bottom of the antenna
housing as shown in Figure 6-9.
Figure 6-9 Connection in the antenna housing
Final preparation
1. Place the antenna housing cover on the housing, Loosely fasten the four fixing
bolts on the cover.
Figure 6-10 Fastening the antenna housing cover
2. Apply grease to the two slot pins. Using a wooden hammer to prevent damage
to paint, insert slotted pins into the pinning holes until the pin head is flush with
the scanner housing surface.
Figure 6-11 How to insert slot pins
CON-0906
50