ONICON F-5100 Inline - Manual (Page 7)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
F-5100 Inline Thermal Mass Flow Meter Manual 05/15 - 0686-11 / 18332 Page 7
1.4 ADDITIONAL HARDWARE THAT MAY BE REQUIRED
1.4.1 Additional Remote Mount Cable
ONICON remote mount meters are provided with 25 ft of cable. Additional cable lengths
of up to 1000 ft may be added without affecting the calibration of the meter.
1.4.2 Gaskets for Flanged Meters
For F-5100 Inline Thermal Mass Flow Meters provided with ANSI class 150 or class 300
flanges require gaskets for proper installation. ONICON does not supply gaskets.
Gaskets used must comply with all relevant AGA and ANSI standards.
1.5 WORKING ENVIRONMENT
F-5000 series meters are designed for installation and use in typical industrial environments that
are free of corrosive liquids and fumes, direct liquid exposure, heavy condensation, temperature
extremes and vibrations. Do not install the meter in direct sunlight.
The operating ambient air temperature range is -5° to 150° F.
The electrical power should be relatively clean, free of high frequency noise, large voltage
transients, and protected from power surges and brown outs.
1.6 WARRANTY & SERIAL NUMBER
Part # Description
17350 25 ft of additional mount remote cable
17351 50 ft of additional remote mount cable
17352 100 ft of additional remote mount cable
IMPORTANT NOTE
ONICON F-5000 series flow meters are individually calibrated. Remote mount electronics
enclosures and sensors must share the same serial number and must be installed together as a
system. Mixing components from different meters will result in significant errors in calibration.
i
Warranty
ONICON provides a 2-year warranty for this product. Certain exclusions apply. Please refer to
Appendix A-2, ONICON’s Terms and Conditions of Sale for details.
Serial Number
The serial number of your F-5100 series flow meter is located on the nameplate attached to the
top of the enclosure. This serial number will also be located on the remote sensor for remote
mount meters.