Olson Technology OTOHP-RFG User Manual

Page 4

OPERATION PANEL DESCRIPTION (CONT.)

7. Down:
8

Set:

9. Exit:
10 Handle: Used to handle the module when being installed or uninstalled
11 Heat dissipation hole:Air flow out of this hole dissipates the heat.
12 TP:
13 Thumbscrew: Fixes the module to the chassis.
14. 30-pin Connector:

Push button, select function or parameter setting.

Push button, confirm function or parameter setting selection.

Push button, exit certain operation mode

Test point for RF output, -20dB, F type male connector

Provides power and signals to the chassis back plane connector

typeismale.

15. Optical Input Port: Port for optical input, connector type is SC/APC.
16. Optical Input Port: Port for optical input connector type is SC APC.
17. Optical Input Port: Port for optical input connector type is SC APC.
18. Optical Input Port: Port for optical input connector type is SC APC.
19. RF Input Port: Port for RF input connector type is F female.
20. RF Input Port: Port for RF input connector type is F female.
21. RF Input Port: Port for RF input connector type is F female.
22. RF Input Port: Port for RF input connector type is F female.

Inspect for bent pins on the backplane connector at the rear of the module
Straighten any bent pins before installing the module

Gently insert each module into a slot in the front of the chassis Be careful to align
the metal guide rails on the top and bottom of the module with the nylon guides in
the interior of the chassis housing

3. Tighten the captive thumbscrew on the front of the module

4. Repeat Steps 1 through 3 to install the remaining modules in the chassis
5. Use an optical power meter to verify that the optical input level meets the

specification values.

INSTALLATION

CAUTION: Using mismatched optical connectors will damage the connectors and
degrade system performance. Ensure that each fiber has a matching connector.