Olson Technology OTOHP-RFG - Manual (Page 2)

SAFETY WARNINGS
LASER RADIATION
The optical fiber connector attached to the OTOHP-RFG quad RFoG receiver emits invisible
radiation that can cause permanent eye damage.
.
Operate the receiver only with the proper optical fiber installed in the receiver optical connector.
Power to the receiver should be turned-off or preferably, disconnected whenever the optical
connector cover is opened and there is no installed fiber (as when the fiber connector is being
installed or removed from the transmitter connector).
AVOID DIRECT EXPOSURE TO BEAM
NEVER
NEVER
NEVER
NEVER
USE ANY OPTICAL INSTRUMENT TO VIEW THE OUTPUT OF THE OPTICAL FIBER
OR CONNECTOR “OPTICAL INSTRUMENT” INCLUDES MAGNIFYING GLASSES, ETC.
LOOK INTO THE OUTPUT OF THE CONNECTOR TO BE ATTACHED TO THE
RECEIVER
LOOK INTO THE OUTPUT OF A FIBER CONNECTED TO A LASER
TRANSMITTER.
LOOK INTO OR USE ANY OPTICAL INSTRUMENT TO VIEW THE DISTANT END
OF A FIBER THAT MAY BE CONNECTED DIRECTLY OR VIA AN OPTICAL SPLIT, TO A
TRANSMITTER THAT MAY BE OPERATING. THIS SPECIFICALLY APPLIES TO FIBERS
THAT ARE TO BE CONNECTED TO RECEIVERS OR OTHER DEVICES AT ANY
DISTANCE FROM THE LASER TRANSMITTER.
PRECAUTIONS
Failure to comply with these general safety precautions and with the specific precautions
described elsewhere in this manual violates the safety standards of the design, manufacture, and
intended use of the device. Olson Technology Inc. assumes no liability for the customer's failure to
comply with these precautions.
Do not operate the receiver outside of its ratings. Doing so may result in unsatisfactory
performance, receiver failure, shortened receiver life span, or a safety hazard.
Do not attempt to modify or service any part of a receiver module. Doing so voids the warranty.
Return the unit to Olson Technology Inc. for service and repair.
Do not restrict airflow in front of or behind the chassis. The receiver should be operated in an
ambient environment between 0 and 50ºC (32 and 122ºF).
Store the module away from corrosive materials, at a temperature between -40 and +70ºC (-40 and
+158ºF), and with no more than 85% humidity, non-condensing.