Olson Technology OTOHP-NMS Mini User Manual
Page 4
OPERATION PANEL DESCRIPTION (CONT.)
6. Handle: Used to handle the module when being installed or uninstalled.
7. Heat dissipation holes: Air flow out of these holes dissipates the heat.
8
.
US B Port: USB protocol type B connection for PC.
9
Thumbscrew: Fixes the module to the chassis.
10. 30-pin Connector: Provides
power
and
signals
to
the
chassis
backplane
,
connector
type
is
male.
11. RJ-45 Port: SNMP protocol, 10Mbps, half-duplex connection.
INSTALLATION
1. Inspect for bent pins on the backplane connector at the rear of the module.
Straighten any bent pins before installing the module.
2. Gently insert the module into Slot1 in the front of the chassis. Be careful to align
the metal guide rails on the top and bottom of the module with the nylon guides in
the interior of the chassis housing.
3. Tighten the captive thumbscrew on the front of the module. The status (STA) LED
should light green
4. Use a USB direct cable to connect the OTOHP-NMS and your computer and run
the “Console Program” software. Refer to the software instructions for details about
these operations.
5. Or use an Ethernet twisted-pair cable (e.g., CAT-6) to connect the OTOHP-NMS
and your computer and run the “SNMP” software. Refer to the software instructions
for details about these operations.
UNINSTALLING THE MODULE
1. Disconnect the USB port from the front of the module.
2. Disconnect the RJ-45 port from the rear of the module.
3. Loosen the thumbscrew on the front panel of the module. CAUTION: Do not pull
on the thumbscrews to remove the module. Pull on the handle that the
thumbscrew goes through to remove the module.
4. Gently remove the module from the chassis.