Olson Technology OTOHP-CH - Manual (Page 6)

OPERATION PANEL DESCRIPTIONS (CONT.)
3. TP/24VDC: Anode for 24V out test point.
DC
4. GND: Ground for 24V out test point.
DC
5. Handle: Used to handle the module when being installed or uninstalled.
6. Heat dissipation hole: Air flow out of holes dissipates heat from the module.
7. Power switch: Turns the power supply module on and off.
8. Thumbscrew: Fixes the power supply module to the chassis.
9. Thumbscrew: Fixes the power supply module to the chassis.
10. 30-pin Connector:
11. 30-pin Connector:
UNPACKING AND CHECKING
All units are tested and inspected before shipment and found to be free of mechanical and
electrical defects
.
However
,
upon receiving your products.
1
.
Examine all shipping containers for any damage caused by shipping.
2
.
Unpack all modules and chassis.
3
.
Keep all packing materials until your inspection is complete
.
When possible, save
the shipping container for future reshipment and
/
or storage.
If damage is discovered
,
file a claim with the carrier immediately and notify your Olson
Technology, Inc. representative as soon as possible
.
Products deemed defective by the
original purchaser must be returned to Olson Technology, Inc. prepaid in the original
packing material (or equivalent) with a Return Material Authorization (RMA) from the
Olson Technology, Inc.
Provides power and signals to the chassis backplane;
connector type is male.
Provides power and signals to the chassis backplane;
connector type is male.
12. IEC Male Plug: Provides input of AC power to the power supply
.
INSTALLING MODULES
If only a single power supply module is to be installed in the chassis, refer to the
section above for powering considerations.
CAUTION: Some components are sensitive to electrostatic discharge (ESD)! Use a
grounding strap to prevent damage to electronic components by ESD. Do not touch
any components not specifically referred to in these instructions.