Olson Technology OTLT-87XX-40-SA - Manual (Page 3)

SAFETY WARNINGS
LASER RADIATION
The OTOT-87XX laser transmitters emit invisible radiation
that can cause permanent eye damage.
AVOID DIRECT
EXPOSURE TO BEAM.
Operate the transmitter only with the proper optical fiber installed in the
transmitter optical connector. Power to the OTOT-87XX should be turned-off or preferably,
disconnected whenever the optical connector cover is opened and there is no installed fiber (as
when the fiber connector is being installed or removed from the transmitter connector).
NEVER USE ANY OPTICAL INSTRUMENT TO VIEW THE OUTPUT OF THE LASER
TRANSMITTER. “OPTICAL INSTRUMENT” INCLUDES MAGNIFYING GLASSES, ETC.
NEVER LOOK INTO THE OUTPUT OF THE LASER TRANSMITTER
NEVER LOOK INTO THE OUTPUT OF A FIBER CONNECTED TO A LASER
TRANSMITTER.
NEVER LOOK INTO OR USE ANY OPTICAL INSTRUMENT TO VIEW THE DISTANT
END OF A FIBER THAT MAY BE CONNECTED DIRECTLY OR VIA AN OPTICAL
SPLIT, TO A TRANSMITTER THAT MAY BE OPERATING. THIS SPECIFICALLY
APPLIES TO FIBERS THAT ARE TO BE CONNECTED TO RECEIVERS OR OTHER
DEVICES AT ANY DISTANCE FROM THE LASER TRANSMITTER.
HIGH VOLTAGE
The inside of the OTOT-87XX contains no user serviceable parts. There is exposed high voltage
inside this unit. Only factory service technicians should open the unit with power applied.
The AC line input fuse is contained in the IEC 320 power input connector. This fuse is a 250V,
FIRE HAZARD
0.5A, 5x20mm, slow blow fuse. To avoid a risk of fire, this fuse should be replaced only with an
identically rated fuse.
SHOCK HAZARD
The OTOT-87XX is designed for indoor use only. Direct exposure to moisture must be avoided .
025-000538 REV 1 4/06/09 Page 3