Olson Technology FRMUC-T-6940 - Manual (Page 3)

025-000440 REV A Page 3
INSTALLATION INTO SCIENTIFIC-ATLANTA 6940 NODE
Install the converter/transmitter in the 6940 node per the instructions located on page 4.
Use caution in handling the SMB connectors on the RF cables used with the converter and the node. Always
remove them by pulling them straight out. Try to pull on the connector, not the cable. Always install them by
pushing them straight in.
If this installation is being done on an operating node, CONNECT THE FIBER TO THE TRANSMITTER
BEFORE PLUGGING-IN THE DC POWER CABLE FROM THE CONVERTER/TRANSMITTER.
If this installation is being done on a non-operating node, CONNECT THE FIBER TO THE
TRANSMITTER BEFORE APPLYING POWER TO THE NODE WHEN THE NODE IS INSTALLED.
DANGER- -LASER RADIATION- -DANGER
THIS UNIT EMITS INVISIBLE LASER RADIATION FROM THE LASER TRANSMITTER THAT
CAN CAUSE PERMANENT EYE DAMAGE
AVOID DIRECT EXPOSURE TO BEAM
APPLY DC POWER AND OPERATE ONLY WITH PROPER OPTICAL FIBER INSTALLED IN
TRANSMITTER CONNECTOR