Northern Airborne Technology 270 - Manual (Page 15)

SM270 Rev. 4.10 Model 270 Universal Interface Amplifier Manual
Section 2 Installation
2.1 Introduction
Information in this section consists of: unpacking and inspection procedures, installation
procedures, post-installation checks, and installation drawings.
2.2 Unpacking and Inspection
Unpack the equipment carefully and locate the warranty card. Inspect the unit visually
for damage due to shipping and report all such claims immediately to the carrier
involved. Note that each unit should have the following:
- Model 270 Universal Interface Amplifier
- Warranty Card
- Release certification
Verify that all items are present before proceeding and report any shortage immediately
to your supplier.
2.2.1
Warranty
Complete the warranty card information and send it to NAT when the installation is
complete. If you fail to complete the warranty card, the warranty will be activated on
date of shipment from NAT.
Note: An appropriately rated facility, e.g. Certified Aircraft Repair Station, must install
this equipment in accordance with applicable regulations. NAT Ltd’s warranty is
not valid unless the equipment is installed by an authorized NAT Dealer. Failure
to follow any of the installation instructions, or installation by a non-certified
individual or agency will void the warranty, and may result in a non-airworthy
installation.
2.3 Installation Procedures
2.3.1 Cautions
Do not bundle any lines from this unit with transmitter coax lines, or AM audio
rectification may result. Do not bundle any input or output audio, or DC power lines
from this unit with 400 Hz synchro wiring or AC power lines. Do not position this unit or
wiring from this unit next to any device with a strong alternating magnetic field such as
an inverter, or significant audio interference will result.
Dec 12, 2006 Page 2-1
ENG-FORM: 805-0108.DOT
CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.