2 interfaces – Norsat O3b 10W BUC User Manual
Page 7
© 2013 Norsat International Inc.
Page 7 of 26
Equipment Working Conditions
1.3.7
Never perform maintenance or make adjustments to the BUC when the power supply is connected.
Important Safety Information
1.3.8
Read the chapters on Installation and System Operation before powering up the BUC.
Do not connect the AC INPUT (prime power) port to a power source until all the other connections
have been made.
Waveguide
1.3.9
Never operate the BUC without a cable or RF load connected to the RF OUTPUT waveguide.
Never stand in front of or look into the waveguide during BUC operations.
2 INTERFACES
J1 / IF IN
2.1
N-type connector is used for the input port as shown in Fig. 2.
Figure 2. N-type IF and MS 12-pin connectors for Ka-band 10W BUC
J2 / RF OUT
2.2
WR28 waveguide is used for the output port as shown in Fig. 3.