Norsat O3b 10W BUC - Manual (Page 17)

© 2013 Norsat International Inc. Page 17 of 26
o SSPA On function
o This button is used to turn on the SSPA of the BUC.
o SSPA Off function (Mute)
o This button is used to turn off the SSPA of the BUC.
o Gain setting
o This button is used to change the gain of the BUC
o Serial Command
o This text box is used to control the BUC with commands via serial communication. If you
click command list button(⑦), You can see the command list. (Refer to the serial Commands
list in 5.1.4)
o UDP Command
o This text box is used to control the BUC with commands via UDP (Ethernet) communication.
If you click command list button(⑦), You can see the command list. (Refer to the serial
Commands list in 5.1.4)
o DebugMode
o This button is used to debug the BUC. It’s not used for operation.
o Command List
o This button shows the command list. (Refer to the serial Commands list in 5.1.4)
o Clear
o This button is used to clear status display window
o BUC Monitoring
o This window shows the current status of BUC output power, LO lock status, temperature,
over temperature, over RF power, external mute.
o Serial Communication setting
o You can set up serial communication parameters.
o (Usable serial port number, baud rate: 57600)
o UDP Communication setting
o You can set up UDP communication parameters.
o IP text box : BUC IP
o TX : BUC UDP(Ethernet) Port
o RX : Master UDP(Ethernet) port
o Status display window
o This window shows the command processing result.
Serial Commands List 5.2.2
Table 2. Serial Commands List
Item Command Example Explanation
1 gst gst Get BUC status
2 sspaon sspaon Turn on SSPA
3 sspaoff sspaoff Turn off SSPA
4 sendipwr sendipwr 192 168 100 2 Write master(PC) ip
5 sendiprd sendiprd Read master ip
6 sendportwr Sendportwr 4001 Write master port
7 sendportrd sendportrd Read master port
8 ipwr ipwr 192 168 100 10 Write BUC ip