Nevion Sublime Control Panels - Manual (Page 12)

VikinX Sublime Control Panels Rev. M
nevion.com | 12
4
LED status indication
4.1 Start-up
The LED located at the front of the control panel indicates the status of the panel. At start-
up, the LED will alternate between red (R) and green (G) every 500ms for about two
seconds. After the start-up sequence the LED will indicate the Alarm state of the panel.
There are two LEDs located at the Ethernet bus. At start-up the boot loader is searching for
update commands on the serial port for about two seconds. During this sequence both
Ethernet LEDs will be blinking. After the start-up sequence the LEDs will indicate the
Ethernet state.
4.2 Alarm states
The LED can either be red (R), green (G), yellow (Y) or have no light (N).
The LED state is here described with twenty letters, each representing 100ms, which totals
to an alarm sequence of two seconds. The X indicates that the LED keeps the color it has
the moment the alarm sequence begins (green, yellow or no light).
Description LED state Alarm Comment
Continuous
green light GGGGG GGGGG GGGGG
GGGGG No alarm.
Status is OK.
Continuous
yellow light YYYYY YYYYY YYYYY YYYYY Unable to
connect to
controller
over
Ethernet. This alarm will be
overwritten by other
alarms
Long red
blinks RRRRR NNNNN RRRRR
NNNNN Power is too
low.
One short
red blink RXXXX XXXXX XXXXX XXXXX Power A
failed Only active if power
alarm dip is set.
Two short
red blinks XXXXX XXXXX RXRXX XXXXX Power B
failed Only active if power
alarm dip is set.
Red with one
short yellow
blink YRRRR RRRRR RRRRR
RRRRR No valid
product key.
4.3 Ethernet states
The LEDs that are located at the Ethernet bus will after the Start-up sequence indicate the
Ethernet states:
On Off / Blinking
Green Valid link No link
Yellow No data Data is transmitted or received