Nevion DA-SDI - Manual (Page 5)

DA-SDI Rev. H
nevion.com | 5
2 Specifications
Electrical Input
Data rate NRZ: 1 to 540 Mbps
Equalisation: Automatic
Cable equaliser and reclocker can be bypassed to support
bitrates down to 1Mbps.
Impedance: 75 ohm
Return loss: >15dB @ 540MHz
Signal level: nom. 800mV
approx. 200mV min. when equaliser switched to Bypass
Connector: BNC
Electrical Output
Number of outputs: 8 (6)
Connector: BNC
Impedance: 75 ohm
Return loss: >15dB @ 540MHz
Jitter: max 0.2UI
Peak to peak signal
level: 0.8V ± 0.1V
Signal polarity 6 non inverting, 2 inverting
Features
Re-clocking: Automatic clock rate detection
Selectable loop bandwidth

Low: 500kHz

High: 1MHz
Supported clock rates: 143, 177, 270, 360 and 540 Mbps
Input equaliser: EQ bypass for non-video formats or low bit rates
Electrical
Power: +5V DC / 3W Max.
Control: Control system for access to setup and module status with
BITE (Built-In Test Equipment) for use with GYDA Control
System.
Supported standards
SMPTE: SMPTE259M, SMPTE297M, SMPTE305M, SMPTE310M
DVB-ASI: EN50083-9
AES: AES-3id (with EQ and RCL switched off)