Nevion WOS-2 - Manual (Page 14)

WOS-2 Rev. H
nevion.com | 14
5.3 RS-422 command set
All commands follow the flashlink protocol, and can be used for direct access to the modules
without use of the GYDA-SC, or for third-party control system integration. The flashlink
protocol can be found on our web page
http://nevion.com
Command Response Comment
? See protocol description The "hello" command
main OK Switch to main position
standby OK Switch to standby position
stat
Vcc=…
One of the following:
mode: main
mode: standby
mode: standby (gpi)
Relay failure Module status
+5V voltage monitoring
Main position
Standby position
Standby pos. GPI active
Relay failure