NCast PR720 - Manual (Page 18)

NCast Presentation Recorder Reference Manual
Disable this selection if access to the network time servers is not available (closed network) or if the unit is
being used in a temporary location with a standalone hub or router (e.g. a tradeshow, conference or demo).
Bootup time will be substantially reduced if the system does not wait for a response from non-existent time
servers.
3.1.9. Serial Number and Revision Information
At the bottom of the Unit Options page internal system information is listed including:
• Serial number of the hardware unit
• Hardware architecture in use and firmware revision numbers
• Software release revision and date for firmware and digitizers
• System date and time
3.1.10.Configuration/Reset Buttons
On the right side of the web page are six buttons which may be used to configure, restart or reset the unit:
• Shutdown – Powers down the unit and is recommended as the proper means to turn off a
Presentation Recorder if it will be idle for some time or is to be moved or reconfigured. All operating
parameters will be properly saved and restored.
• Reboot – Shuts down and then restarts the unit. This operation may be needed to clear problems
after a power brownout or other unexpected glitch.
• Date & Time – Controls setup of Date & Time and access to internal or external time servers.
• Factory Defaults – All operating parameters are reset to the Presentation Recorder’s initial factory
configuration. Nothing is saved and the reset is irreversible.
• Export Settings/Import Settings – Export or Import ALL configuration settings for this unit.
3.2. P
ASSWORDS
The Passwords page provides for entry of four different password types to control access to the Presentation
Recorder.
NCast Corporation Revision 1.1
Page 18