Mr. Coffee BVMC-ECMP1000 Series Café Barista - Manual (Page 5)

9
HOW TO SELECT THE RIGHT CUP
Please make sure to select your cup according to the following chart:
BEVERAGE AMOUNT
Espresso Single ( )
Double ( )
1.25 oz
2.5 oz
Cappuccino Single ( )
Double (
)
6 oz
10 oz
Latte Single ( )
Double ( ) 12 oz
15 oz
NOTE: The total amount of the beverage can vary depending on the type of
milk used and Froth Control Knob setting.
SELECTING THE RIGHT COFFEE
THE COFFEE
The coffee should be freshly ground and dark roasted. You may want to try a
French or Italian roast ground for espresso. Pre-ground coffee will only retain
its flavor for 7 – 8 days, provided it is stored in an airtight container and in
a cool, dark area. Do not store in a refrigerator or freezer. Whole beans
are recommended to be ground just before use. Coffee beans stored in an
airtight container will keep its flavor for up to 4 weeks.
THE GRIND
This is a vital step in the espresso making process if you are grinding your
own coffee and takes practice. The coffee must be of a fine grind.
• The correct grind should look like salt.
• If the grind is too fine, the water will not flow through the coffee even
under pressure. These grinds look like powder and feel like flour when
rubbed between fingers.
• If the grind is too coarse, the water flows through the coffee too fast,
preventing a full-flavored extraction.
Be sure to use a quality grinder for uniform consistency. A conical or burr mill
grinder is recommended for a consistent and fine espresso grind.
8
BEFORE USING YOUR APPLIANCE
FOR THE FIRST TIME
Step 1 - CLEAN THE APPLIANCE
1. Make sure unit is unplugged and the On/Off switch is in the Off position
“O”.
2. Remove stickers and labels from the unit.
NOTE: REMOVE THE RED PLUG FOUND AT THE BASE OF THE WATER
RESERVOIR.
3. Remove and wash the water reservoir, milk reservoir, porta-filter, 2 filters
and measuring scoop in a mixture of mild detergent and water. Rinse
each thoroughly and place back onto appliance.
NOTE: Porta-filter and water reservoir are NOT dishwasher safe.
Step 2 - PRIME THE UNIT (must be completed prior to first use)
1. Plug unit in and turn unit ON (“l”) using the On/Off switch.
2. Fill water reservoir up to the “MAX” level with water and place back on
unit.
3. Fill milk reservoir up to the “MAX” level with water and place back on
unit. Be sure to firmly push the milk reservoir into place until Cappuccino
and Latte buttons illuminate.
4. Place porta-filter in the unit ensuring it is properly locked. For more
instructions, refer to the “Placing the Porta-Filter” section on page 11 of
this manual.
5. Place a large cup under porta-filter.
6. Aim the tip of the frothed milk dispensing tube inside the cup.
7. Once all 3 lights on the control panel stop pulsing and remain
illuminated, press the Espresso button “ ” and hold until the pump
starts then release the button. Once the pump starts, let it run until the
unit stops automatically or until you see water flow from porta-filter. To
stop the process yourself, press the Espresso button “ ” again.
8. If you do not see water flow from porta-filter after unit stops
automatically, repeat step 7 until you do.
9. Empty cup and place back under porta-filter.
10. Press the cappuccino button “
” and hold until pump starts
then release it. Once the pump starts, let it run until the unit stops
automatically or until you see water flow from the frothed milk
dispensing tube. To stop the process yourself, press the Cappuccino
button “ ” again.
11. Once step 10 is complete, the 3 control panel lights will remain
illuminated indicating that the unit is ready for use.
BVMC-ECMP1000_BVMC-ECMP1001_13ESM1.indd 9-10 9/30/13 2:33 PM