Standby mode, Set clock, Standby mode set clock – MovinCool CM25 User Manual
Page 41: Operation (wall mounted controller only) (cont.)
41
OPERATION
(Wall Mounted Controller ONLY) (cont.)
Standby Mode
When power source is supplied to the unit, the wall mounted controller is in
standby mode.
During standby mode, the control panel displays time.
Set Clock
Prior to operating the unit, set the clock of the controller to the correct time as
shown in the steps below.
1. Press and hold the SET TIME button for 3 seconds “Day of the week” blinks.
2. Press UP (
) or DOWN (
) button to select “Day of the week”.
3. Press ENTER button. “Hour” blinks.
4. Press UP (
) or DOWN (
) button to select correct hour.
Note: AM or PM changes with hour automatically.
5. Press ENTER button. “Minutes” blinks.
6. Press UP (
) or DOWN (
) button to select correct minute.
7. Press ENTER button to complete clock setting.
Note:
1. Check clock periodically to confirm clock accuracy.
2. The clock defaults after 20 days from the point of shutting power supply. In this
case, set the clock again.