MovinCool CM25 - Manual (Page 26)

26
INSTALLATION (cont.)
Supplied Wall Mounted Controller Connection (cont.)
4. Depending on installation conditions, there are two methods to insert the
shield wire through the back cover of the controller.
Method A)
Insert the shield wire through the hole of the back cover.
Method B)
Break the dent portion of the front cover by tool (pliers, etc.). Remove the dent
portion and insert the shield wire through the hole.
5. Reassemble the controller board to the back cover with four (4) screws.
HOLE
FRONT
COVER
DENT PORTION
HOLES