Monster Remote Access RF/IP Card 100 - Manual (Page 7)

ENGLISH
• Using a #0 Philips head jeweller’s screwdriver,
remove the 2 screws holding the cover plate over
the SNMP slot. Keep the screws for later use.
• Remove the cover plate.
• Inside the slot are two rails: one at the top and
one at the bottom, aligned with each other and
positioned towards the right side of the slot.
Locate these rails by touch—they are used to
position and guide the Monster Remote Access
RF/IP Card 100.
• Insert the Monster Remote Access RF/IP Card 100
into the slot, making sure to slide the card along
the rails in the slot. The card should slide into the
card connector at the back of the slot. Press gently
so that the faceplate of the card touches the rim
of the slot.
• If the card does not seat with gentle pressure,
it may not be aligned properly. Remove the card
from the slot and try again.
• Once the card is seated properly, the holes in the
faceplate should align with the screen holes in the
slot. Use the cover plate screws to attach the card
to the backplate of the PowerCenter.