MK Products Pulse+ - Manual (Page 9)

Pulse+ Owner's Manual Page 9
Section 1 SPECIFICATIONS
PRIMARY POWER INPUT - 115VAC 50-60 Hz 1 Ampere
WELDING POWER INPUT - D.C. 10-60 Volts 0 to 300 Amperes
WELDING POWER OUTPUT - D.C. 10-58 Volts 0 to 300 Amperes
PULSE CAPACITY - Pulsed “On” Period - 1 to 10 milliseconds
- Pulse “Off” Period - 1 to 20 milliseconds
- Pulse Frequency Variable from 30 - 500 pps
SIZE - 18”W x &-3/4”H x 14”L
WEIGHT - 31 lbs.
ENVIRONMENT - 20 to 105 degrees F, 90% humidity without
condensation 0 - 10,000 feet elevation.
Units may be stacked vertically up to four
high.
AREA REQUIRED - Access required both front and back for
connectors and four inches on sides for air
circulation.
PULSE OUTPUT VOLTAGE - Equals connected power supply output
voltage, minus approximately a two volt
drop.
BACKGROUND LEVEL - Is automatically adjusted depending on
connected power supply output voltage, wire
characteristics, wire feed rate, and other
welding characteristics. It will typically be
30 to 130 amperes.
CONTROLS - On/Off Switch
Pulse “On” Time - Controls high current
density pulse duration which should be
adjusted to achieve welding metal droplet
formation, detachment, and axial transfer
to work.
- Pulse “Off” Time - Controls the average
welding heat (energy) and should be ad
justed to be consistent with wire feed speed
used.
- Voltmeter - Reads average voltage while
welding.