beautypg.com

Wiring the power inputs – Microsens MS655033X User Manual

Page 13

background image

Wiring the Power Inputs

Please follow the steps below to wire power lines from the terminal block

to the compliant external DC power source.

1. Before wiring, make sure the power source is disconnected.

2. Using the wire-stripping tool, strip a short piece of insulation from the

output wires of the DC power source.

3. Identify the positive and negative feed positions for the terminal block

connection. See the symbols printed on the panel indicating the

polarities and DC input power range in voltage.

Plugs for Power 1 & Power 2

4. Insert the exposed wires into the terminal block plugs. Only wires with

insulation should extend from the terminal block plugs. Note that the

polarities between the wires and the terminal block plugs must be

positive to positive and negative to negative.

5. Use a slotted screwdriver to tighten the captive screws.

¾

Use Copper Conductors Only, 60/75

°

C, tightening to 5 lb-in

¾

The wire gauge for the terminal block should be in the range

between 12~ 24 AWG.

ATTENTION

10