Microsens RS-232 - Manual (Page 5)

4
2. Installation
2-1. Installing the Fiber converter
Mounting on DIN-Rail
⇒ Remove the four screws on the both sides of the converter.
⇒ Place the converter on the mounting bracket.
⇒ Align the screw holes on the bracket with the holes on the both sides of
the converter. (See Fig. 3)
⇒ Insert the 2 x 5mm screws and tighten them until they are secure.
Fig. 3
⇒ Position the fixed DIN-rail clip on the backside of the bracket on to the
DIN-rail.
⇒ Pull up the moveable DIN-rail clip to attach the bracket to the DIN-rail,
and then release the clip.
(See Fig. 4)
⇒ Make sure the converter is securely mounted on the DIN-rail.
Fig. 4