Microsens MS40020x - Manual (Page 11)

9
Installing Converters module
This installation is only for mounted in converter chassis converter module.
You can follow the steps below to install converter module.
A 、 Remove the blank bracket by rotating thumbscrew counterclockwise.
Put the blank bracket aside, but don’t discard blanket bracket.
B 、 Open the rack mount ear kit. The kit contains two-rack mount ear
(with thumbscrew) and four screws.
C 、 Attach rack mount ear on both sides of the converter module by using
a screwdriver to secure the rack mount ears.
D. Install the converter module by inserting it into the guides and sliding it
in until it stops. Press it firmly until the power plug in the chassis plugs into
the converter module receptacle. Slide the converter module in smoothly.
E. Gently push the thumbscrews in and turn clockwise to tighten. Do not
over tighten the thumbscrews.