Microsens MS400190 - Manual (Page 6)

4
TP Port
Attach TP Cat. 5 cable to TP port
The 1000 TP port is transmit/receive wires
auto-link (e.g. either MDI-X or MDI-II). It will
auto-cross-connect transmit/receive wires to a
switch or to a workstation, be sure the proper
wiring and the Link LED status
Fiber Port
Attach the fiber cable. The Tx, Rx fiber cable
must be paired at both ends
Converter
TP Port
1000FDX with NWay flow control
Converter
Fiber Port
1000FDX with NWay flow control
Link partner must be 1000FDX with NWay flow
control
Warning:
 The converter TP 1000FDX NWay port must be connected to a
NWay TP device. When Converter TP Port (NWay) connecting to
a non_NWay 1000FDX TP partner, it could not inter-operate
properly between local and remote TP partners.
 Ensure all network nodes are configured at an identical operation
mode. Improper operation and flow control mode between TP and
Fiber port connections will render the LAN to work poorly.
2-3 LED Description
LED Color Function
FX LINK Green
Lit when fiber connection is good
Blinks when fiber data is receiving
FX FDX Green Lit when fiber full-duplex mode is active
TP LINK Green Lit when TP connection is good
TP FDX Green Lit when TP full-duplex mode is active
TP ACT Green Blinks when TP data is receiving
PWR Green Lit when
+5V power is coming up
2-4. DC Jack and AC-DC Power Adapter
The DC jack's central post is 2.5mm wide
DC Jack : 2.5mm
DC Input : +5V
(Converter DC Current Consumption: 1A when
operation at full speed/load)