Microsens MS400220 - Manual (Page 14)

10
Converter module Installation
This installation is only for mounted in converter chassis converter module. You can
follow the steps below to install modular converters.
A. Remove the blank bracket by rotating thumbscrew counterclockwise. Put the blank
bracket aside, but don’t discard blanket bracket.
B. Open the rack mount ear kit. The kit contains two-rack mount ear (with thumbscrew)
and four screws.
C. Attach rack mount ear on both sides of the modular converter by using a
screwdriver to secure the rack mount ears.
D. Install the modular converter by inserting it into the guides and sliding it in until it
stops. Press it firmly until the power plug in the chassis plugs into the modular
converter receptacle. Slide the modular converter in smoothly.
E. Gently push the thumbscrews in and turn clockwise to tighten. Do not over tighten
the thumbscrews.