Microsens MS400220 - Manual (Page 12)

8
FDX (UTP)
Amber Full-duplex mode
Off Half-duplex mode or link down
LNK/ACT
(Fiber)
Green Link up
Blinks Transmitting
Off Link down
FDX/COL (Fiber)
Amber Full-duplex mode
Off Link down
DIP-switch
The DIP-switch is used to configure operation mode for LLF (Link Lost Forwarding)
and operation mode for Copper/Fiber port. The default value of Dipswitch is OFF.
 10/100/1000Base-T to 1000Base-FX converter module
S/W No Status Description
1
ON LLF Enable
OFF LLF Disable
2
ON Pure converter mode
OFF Switch converter mode
3
ON Reserved
OFF Reserved
Link Lost Forwarding: When LLF is enabled, it will allow copper port link failure to be
reported to the Fiber side and also allow Fiber link failure to be reported to the copper
side. Therefore, a link loss forward feature is provided in both copper and Fiber side.
Pure Converter mode: When pure converter mode is enabling (on), it operates with
the minimum latency. The transmission flow does not wait until entire frame is ready,