Microsens MS655208 - Manual (Page 17)

14
4. Power on the Industrial switch. How to wire the power; please refer to the
Wiring the Power Inputs section. The power LED on the Industrial switch
will light up. Please refer to the LED Indicators section for meaning of
LED indicators.
5. Prepare the twisted-pair, straight through Category 5e/above cable for
Gigabit Ethernet connection.
6. Insert one end of Category 5e or above cables into the Industrial switch
Ethernet port (RJ-45 port) and another end of category 5e or above cables
to the network devices’ Ethernet port (RJ-45 port), ex: switch, PC or
Server. The UTP port (RJ-45) LED on the Industrial switch will light up
when the cable is connected with the network device. Please refer to the
LED Indicators section for LED light meaning.
Note Be sure that the connected network devices support MDI/MDI-X. If
it does not support, then use the crossover cable.
7. When all connections are all set and LED indicators all show in normal,
the installation is complete.