Microsens MS655100PX-48 - Manual (Page 16)

13
Hardware Installation
In this paragraph, we are going to mention how to install the 5 10/100TX w/ 4 PoE
Injector Industrial Switch and the installation points attended to it.
Installation Steps
1. Unpack the packaging.
2. Check whether the DIN-rail clip is screwed on the Industrial switch. If not, please
refer to the DIN-Rail Mounting section for DIN-rail installation. If users want to wall-
mount the Industrial switch, then please refer to Wall-Mount Plate Mounting section
for wall-mount plate installation.
3. To hang the Industrial switch on the DIN-rail or wall, please refer to the Mounting
Installation section.
4. Power on the Industrial switch. Please refer to the Wiring the Power Inputs section
for knowing the information about how to wire the power. The power LED on the
Industrial switch will light up. Please refer to the LED Indicators section for indication
of LED lights.
5. Prepare the twisted-pair, straight through Category 5 cable for Ethernet connection.
6. Insert one end of the RJ-45 cable (category 5) into the Ethernet port (RJ-45 port) of
the Industrial switch and the other end to the network devices
’ Ethernet port, ex:
Switch PC or Server. The corresponding LED indicators on the Industrial switch will
light up when the cable is connected with the network device. Please refer to the
LED Indicators section for LED light indication.
7. When all connections are set and LED lights all show in normal, the installation is
complete.