Microsens MS453510 - Manual (Page 10)

6
Desktop Installation
Set the switch on a sufficiently large flat space with a power outlet nearby. The
surface where you put the switch should be clean, smooth, level and sturdy.
Make sure there is enough clearance around the switch to allow attachment of
cables, power cord and allow air circulation.
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the switch is grease and dust
free.
B. Remove adhesive backing from your Rubber Pads.
C. Apply the Rubber Feet to each corner on the bottom of the switch. These
footpads can prevent the switch from shock/vibration.
Power On
Connect the power adaptor to the power jag on the rear panel of the switch. The
other side of power adaptor connects to the power outlet. The external power
supply in the switch works with DC power in 12V/0.8A. Please check with the
power indicator on the front panel to see if power is properly supplied.