MicroLinks UM06 - user guide - Manual (Page 12)

10
again to return to preview.
(12) Sharpness : On/Off sharpness mode. Please refer to Section 1.2.3-(2).
1.3 Microscope introduction:
1.3.1
IR Remote Area/Indicator
When both the HDMI and USB indicator lights are on, the microscope is in standby
mode.
Caution: Please remove the transparent protection sheet on the IR receiver area.
(1) IR remote control aiming area○ a : The indicator will blink whenever buttons
are pressed. The indicator will blink, if the indicator did not blink means the
signal was not delivered and please repress again.
(2) HDMI indicator○ b : When lit up, the device is in HDMI mode.
(3) USB indicator○ c : When lit up, the device is in USB mode. The light will flicker if
the microscope is not connected to a PC.
○
b ○ c
○
a