Metz MECABLITZ 58 AF-1 digital Canon - Manual (Page 114)

ķ
Adjusting the settings for slave group B
• Press the "Para" key repeatedly until B TTL (for slave group B) appears on the
LC display.
• While B TTL is displayed, the (-) and (+) keys can be used to adjust the flash
exposure correction value for the slave flash units in group B, from -3 f-stops
(EV) to +3 f-stops (EV) in 1/3 increments.
• Press "Return" to save your settings. If the "Return" key is not pressed,
the settings will be saved automatically after approximately 5 seconds.
Adjusting the settings for slave group C
• Press the "Para" key repeatedly until C or C TTL (for slave group C) appears on
the LC display.
• To activate slave group C, press the "Mode" key repeatedly until C or C TTL (for
slave group C) appears on the LC display. While C TTL is displayed, the (-) and (+)
keys can be used to adjust the flash exposure correction value for the slave flash
units in group C, from -3 f-stops (EV) to +3 f-stops (EV) in 1/3 increments.
• To deactivate slave group C, press the "Mode" key repeatedly until only C
appears on the LC display.
• Press "Return" to save your settings. If the "Return" key is not pressed,
the settings will be saved automatically after approximately 5 seconds.
The settings for the slave group C are visible only as they are being enter-
ed, as the system does not allow them to appear on the display panel of
the master flash unit after they have been saved.
Setting the remote channel
• Press the "Para" key repeatedly until "Ch" flashes on the LC display.
• Set the remote channel using the (+) and (-) keys.
☞
• Press "Return" to save your settings. If the "Return" key is not pressed,
the settings will be saved automatically after approximately 5 seconds.
Setting the zoom position of the reflector
• Press the "Para" key repeatedly until "Zoom" appears on the LC display.
• Set the zoom position using the (+) and (-) keys.
• Press "Return"
to save your settings. If the "Return" key is not pres-
sed, the settings will be saved automatically after approximately 5 seconds.
Adjusting the settings for the master flash unit
• Press the "Para" key repeatedly until M or M TTL (for master flash unit) appe-
ars on the LC display.
• To activate the master flash unit, press the "Mode" key until M TTL appears on
the LC display. While M TTL is displayed, the (-) and (+) keys can be used to
adjust the flash exposure correction value for the slave flash units of group A,
from -3 f-stops (EV) to +3 f-stops (EV) in 1/3 increments.
• To deactivate the master flash unit, press the "Mode" key until only M appears
on the LC display.
• Press "Return" to save your settings. If the "Return" key is not pres-
sed, the settings will be saved automatically after approximately 5 seconds.
Canon manual remote
Adjusting the settings for slave group A
• Press the "Para" key repeatedly until A (for slave group A) appears on the LC
display.
• While A is displayed, press the "Mode" key repeatedly until M (manual remo-
te) appears in the display next to the A.
• While A M is displayed, the (-) and (+) keys can be used to adjust the partial
light output setting for the slave flash units of group A, from 1/1 to 1/128.
114