Metz MECABLITZ 24 AF-1 C_N_O_P_S digital - Manual (Page 85)

• Never throw exhausted batteries on to a fire!
• Exhausted batteries should be immediately removed from
the flash unit. Lye leaking out of spent batteries will dam-
age the unit.
• Never recharge dry-cell batteries!
• Do not expose the flash unit or battery charger to dripping
or splashing water (such as rain)!
• Protect the flash unit from excessive heat and humidity! Do
not store the flash unit in the glove compartment of a car!
• Never place material that is impervious to light in front of,
or directly on, the reflector screen. The reflector screen must
be perfectly clean when a flash is fired. The high energy of
the flash light will burn the material or damage the reflec-
tor screen if this is not observed.
• Do not touch the reflector screen after a series of flash
shots. Danger of burns!
• Never disassemble the flashgun!
DANGER: HIGH VOLTAGE! There are no components
inside the flashgun that can be repaired by a layman.
• When taking a series of flash shots at full light output and
fast recycling times as provided by NiCad battery opera-
tion, make sure to observe an interval of at least 10 mi-
nutes after 15 flashes, otherwise the flash unit will be over-
loaded.
• The mecablitz may only be used in combination with a
camera-integrated flash unit if the latter can completely be
folded out!
• Quick changes in temperature may cause condensation.
Therefore give the flashgun time to acclimatize!
85
ķ
709 47 0261.A2 24AF-1CNOPS 14.12.2010 13:27 Uhr Seite 85