Step 5, You’ll need – Dynex DX-WD1201 User Manual

Page 11

Text mode
Original mode

DX-WD1201

Need help? Call 800-305-2204

Step 5:

Slide the end moldings (W) onto the notched edges of the ends (A and B).
Fasten the top skirt (J) to the angle brackets (O) on the stop molding (I). Use a Phillips screwdriver and three
black 9/16" large head screws (U).

Note: There are no pre-drilled holes in the top skirt (J). The screws will tighten into the groove.

You’ll need:

U (3)

Phillips screwdriver

DX-WD1201_11-0421_MAN_V3_English.fm Page 11 Friday, April 29, 2011 10:57 AM