Starting the machine – Dolmar HT-2249 D User Manual

Page 10

STARTING THE MACHINE

Move at least 3 meters away from the place of refuelling. Place the Hedge
Trimmer on a clean area of ground make sure that the cutting tool does not
come into contact with the ground or any other objects.

Cold starting (When the engine is cold or it has been stopped for more than 5

minutes or when fuel is added to the engine.)

1. Push the I-O switch (1) to “I” position.

2. Squeeze first the lock lever A and then the throttle lever B. (fig.1)

3. Keeping the throttle lever B depressed, then press the throttle lock C inward.

(fig. 2)

4. Keeping throttle lock C depressed, release the throttle lever B. this will lock

the throttle lever B in position. (fig. 3)

5. Give a gentle push on the primer pump (2) repeatedly (7 to 10 times) until

fuel comes into the primer pump.

6. Move the choke lever (3) to position( ).

7. Hold the unit down firmly so you will not lose control while cranking the

engine. If not held down properly, the engine could pull you off balance or
swing the cutting blade into an obstruction or your body.

8. Slowly pull the starter grip until resistance is felt and continue with smart pull

until initial ignition are heard.

9. Depress the choke lever (3) to the position ( ) and pull the starter rope

again until the engine starts.

10. As soon as the engine starts, immidiately tap and release the throttle, thus

releasing the half-throttle rock so that the engine can run in idle.

11. Run the engine for approximately one minute at a modeate speed before

aplying full speed.

Note:

•

If the starter handle is pulled repeatedly when the choke lever

remains at “ ” position, the engine will not start easily due to

excessive fuel intake.

•

In case of excessive fuel intake, remove the spark plug and pull

the starter handle slowly to remove excess fuel. Also, dry the

electrode section of the spark plug.

Hot starting: (Restarting immediately after the engine has stopped) When

restarting a hot engine, first try the above procedure: 1, 5, 7, 8. If the engine

does not start, repeat above steps 1-11.

Note: Do not pull the starter rope to its full extent and do not allow the

starter grip to be retracted without control, ensure that it is

retracted slowly.

(2)

(3)

(fig.1)

(fig.2)

(fig.3)

(1)