Metric Halo Thump - Manual (Page 19)

Operation
19
Fader
Figure 4.4: Mix Fader
The faders are used to control the output gain of the oscillators. This allows you to set the mix level of each tone.
Tooltip Control
Figure 4.5: Tooltip Control
This button toggles the tooltip display. When enabled, tooltips will be shown when the mouse hovers over a
control. When the tooltip display is disabled, you may still see tooltips by holding down the
? key and hovering
over a control.
Oscillator Pitch History
Figure 4.6: Pitch History Display
This display shows the activity of the two oscillators; Oscillator 1 is shown in green, Oscillator 2 in orange. As
the display scrolls from right to left, each trace displays the oscillator output. As the oscillator pitch goes up in
frequency, the trace goes higher in the window. As the oscillator output gets louder, the trace gets brighter.